Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

Daud Suleiman

À rejoins en date due:

Dec. 14, 2014

Points

440

Commentaire(s)

9

Questions votée(s)

1

Réponses votée(s)

2

Votes positifs

0

Votes contre

3

Votes reçus

0

Votes négatifs reçus

0

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

0

2002 VW Jetta manual transmission Evo-One installation advice needed it

I need to install Evo- one for 2002 vw jetta manual trans. Only found Guide # 18171 ( for Automatic : connection and programming) + sacrficing a key. My Question for manual trans same model and year is it the same as in guide # 18171 without cutting the yellow wire or there is a diffrenet wiring connection and modul programming ?: I don't see clutch wiring or specific wiring guide for 2002 vw manual transmission.. I am confused how to do the right wiring and programming .as well. How I install Evo-one on this car? need RIGHT GUIDE. Thanks

0

Evo all stuck on red led,WHY can not be programmed?

Well this Evo all was programmed well on 2015 toyota rav4 every thing was excellent, but to make my work nice and clean I inplugged all connections after main one(my mistake) Did not notice it. On reconnecting everything back,the evo all stuck on red led.the remote wont start unless the key is in the ignition.tried reprogrammed it the redf led wont change.So I.used an other new module fo the above mentioned car.Now, I am stuck with. this module. Is it gone? tried all suggested solutions:REflashed to 0.99 Firmware tried to master reset it,the red led never changed. I have only 2 chaneces more left to be REflashed it. I am tring to install it on 2009 ford escape all connections done well ready for evo all.I want to know what should I do here? dump it? module # 001A07232316 updated firmware- version 71.53 THanks

0

Why parking lights is on?

Done with installing (Evo all+ prostart RS- regular installation).2019 grand caravan starts good + parking light is fine,all is fine (tested -white/green with 1.5k ohm).The only issue is when I start the car normaly with the car key the parking light comes up and stays on even the light switch is @ off position. I shut the engine off the parking light goes off,too. All switch -positins are working fine .What seems the problem here?Thanks.

0

2012 orlando evo all programming step 9 won't pass it,why?

evo all #001A06737960.Guide#29071 as is.RS;Prostart ct-5072. All connections looks good.Evo all programmed perfect,untill step 9 : Afterr yellow led turns off blue comes up soild (sometimes never show up).Also,noticed : the RS antenna's led goes off after, the 5- seconds step(WHY),does that not will affect transmitter communications. Also.need confirmation on ; The RS have 2 wires(12+) with fuses of 20a each(usually); should these fuses value changed to 2a ,cause the Evo all Yellow/blue wire was estated as in the above guide fused by 2A when connected to positive (12+).OR; Is it better, seperate each connection alone connected to (12+) ;RS=20a's and evo all Y/B=2a fuse? .There is something wrong ,here!..Went through all evo all trouble-shooting couldn't figure it out...Thanks.

0

Whats gone wrong here ,2019 corolla H-key with Evo all?

2019 toyota corolla H-key :- installing Pro start ct-5472 tw with Evo all ; service # 001A06 634849.Firmware updated + installation guide# 62011.All connctions are good. Evo all device programmed and connected perfect.The car starts one second,then kept cranking no start.Dash-board sign BATTERY comes up (?).Evo all : RED and YELLOW leds stay on after each crank.The car is basic;without; OEM alarm,remote or TMP wire(pin 28 empty @ JB).The RS works fine with the key in igniion =no issues at all..Where am I lost track?..Thanks.

0

Why 2007 Chevy Optra bypass not listed ?

Well, did some research: This car in CANADA is an imported GM Korean-DAEWOO and SUZUKI FORENZA [U.S]. Which is which?.Anyway I got my hand on one [My friend, got tired of running around, even the dealer REFUSED install RS - Lives @ YUKON.CA. It gets too cold here] HOW TO INSTALL REMOTE START ON this car? Finding the RS wiring is not a problem, by testing , but bypassing the KEY is the main issue,here I s it pass lock- type as most GM?. i did a lot of installations with FORTIN devices, Should I ignore this car as others did?.Use 791 interface module ? Any ideas? . Thanks.

0

where did I stuck with evo all?

I bought me a new one EVO ALL (2014) from e-bay ( Cause, I have been told device made under 2013 will not work )  : The Service No: 00A06 759436. Programmed and updated with the  internet 2009 escape standerd key  : Option; D1 is OFF= not to confused the car ,and A 5, A6 are OFF = not to let car start by itself . Every step went well as estated in the  guide #34451(regular installation) last step: Yellow and red leds alternated.Good. Did the DCRYPTOR + Updated the device,then plugged it  into the car : Tried to remoe start, result ; Ignition turns on , no crank and no start . Did the DRCYPTOR  twice with no problem with link -manager . Put the car- key in the ignition to TEST : Car remote started fine .Leads to two things : Something wrong either the EVO ALL or it's wiring . All wiring connections look fine ,No problem with the programming (evo all- steps : on pagr 6) . So, did I miss something,here?. My problem I have ONE KEY for this car,other wise, I wouldn't use the Drcyptor. Iam stuck . I Need  help and thanks to every one.

0

why the DECRYPTOR tap doesn't show up ?

2009 escape one key - programme - evo all ( service number:001A06 129276 )+ flash link manger 3.62 . Programmed evo all guide# 34451successfully , connected to flash link manager to decryptor : Result : NO decryptor tap showed up + status information is correct , update tap says : your device reached flash imit. What shall I do here?.. Thanks.

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer